Timber-Line Installation

Simplified Installation Instructions (no alteration of saddle slot).




 

 


Timber-line is a piezo cable pickup coupled to an 18 volt, low-noise, high input impedance preamp with twice the dynamic range of 9-volt preamps.

The increased dynamic range and adjustable bass trim pot gives musicians a more natural and full sound. Timber-line is the perfect piezo pickup system for musicians who want a more complex signature from their acoustic guitar.

 
Feature Benefit
Unitary full length pickup Accommodates all string spacings and gets a more even response from the guitar’s top
Co-axial cable design Can get a more complex signature sound of the guitar due to 360 degrees of vibrations along its length
High headroom Allows for twice the dynamic range of a 9 V system, hard strumming, and reduces piezo “quackiness”
Dual source capability Allows the user to combine with a mic, magnetic or soundboard transducer for greater complexity of signal
Easy to install Installation intended for guitar builders and luthier-techs
Adjustable bass trim control Simulates the air resonance of a typical acoustic guitar, warms up bottom end
Stereo buffer upgradable Allows buffering a second signal to ensure proper impedance match

Technical Specifications

Power requirements — 9 to 18 Vdc

Power consumption — 1.0 mA @ 18Vdc

Battery life — approximately 500 hours @ 18Vdc

Maximum signal swing, @ onset of clip —- 5.7V RMS @ 18Vdc

Frequency response — -3dB @ <10Hz, 30KHz Gain — 14dB

Thd
1V out, 1KHz — <.005%
1V out, 20Hz to 20KHz — <.03%

Noise ref. to input:
Wideband — -105dBV
A weighted — -112dBV

Control function, internal trimpot — Broadband bass boost +4db @ 80Hz

Control function, external tone — Passive treble cut

Copyright © 2006 D-TAR. All Rights Reserved
www.d-tar.com